Hello All,
Hopefully somebody may have some ideas regarding the following please ....,
I'm putting an XLS chip into an LGB 2095 loco with 2 motors and keep getting a short circuit ?, bogies have 22962 1 and 22962 2 on them ( 4 wires from motor bogies),
I've placed wires to each motor separately to check direction and the both motors hum as they would via a digital controller (Massoth), I've put all wires together and again the motors hum as they would do, both motors turn when power is applied so all OK so far.
I've now connected all the motor wires into the XLS chip .. 2 into motor+ and 2 into motor - then to make sure I've put them in the correct way for direction placed wires to the top screws on the XLS only for it to get a short circuit ?, any ideas why this is happening please. Thinking the chip may have been at fault I've done the same with different XLS chip but the same happens,
Many thanks for any ideas at all.
Hopefully somebody may have some ideas regarding the following please ....,
I'm putting an XLS chip into an LGB 2095 loco with 2 motors and keep getting a short circuit ?, bogies have 22962 1 and 22962 2 on them ( 4 wires from motor bogies),
I've placed wires to each motor separately to check direction and the both motors hum as they would via a digital controller (Massoth), I've put all wires together and again the motors hum as they would do, both motors turn when power is applied so all OK so far.
I've now connected all the motor wires into the XLS chip .. 2 into motor+ and 2 into motor - then to make sure I've put them in the correct way for direction placed wires to the top screws on the XLS only for it to get a short circuit ?, any ideas why this is happening please. Thinking the chip may have been at fault I've done the same with different XLS chip but the same happens,
Many thanks for any ideas at all.